Elmer's Disappearing Purple Glue Stick (40g)
Elmer’s Disappearing Purple Glue Stick is a safe and non-toxic adhesive that can be used to improve bed adhesion on some 3D printers with a glass build plate. This glue adheres to your printer’s build plate and provides a stickier surface that parts attach to.
This is the glue stick that Markforged recommends you use when printing with the Mark Two 3D printer. Elmer’s Disappearing Purple Glue Stick should be applied to the glass build plate to form a thin but consistent layer. The glue will remain sticky, which is useful if you are printing larger parts or if you are printing parts that are very thin at the bottom. And perhaps best of all, this glue just peels off the build plate afterwards, with very little cleaning needed, and the glue can be stored away for over a year without degradation.
This is a very high quality product, with it being the only third-party glue stick that’s recommended by Markforged. However, this glue stick can be difficult to get a hold of in the United Kingdom. Thankfully, we have a new batch in stock ready to go, so there’s no need to purchase yours from the US and have it imported into the UK.